Repair faucet method How to install various faucets

The frequency of taps used in the home is also relatively high. No matter what the product is used for a long time, there will be some problems. At this time, it is necessary to repair it. First of all, it should find the right reasons, so that it will be more convenient to handle. The following we will introduce you to the method of repairing faucets and how to install various faucets.

Repair faucet method introduction

1, change the axis of the faucet

First of all, when repairing, be sure to understand the reason why the faucet is leaking. If the faucet is worn out, then use the pliers to loosen the capping bolt and then remove the shaft washer. It's good to change it again.

2, water stop tape damage

Whether the water tap is tight or you have to use a wrench to remove the counterclockwise rotation of the tap. At this time, you can tape it in a clockwise manner. After you do it, re-tighten the tap. Try to see if it will leak.

3, faucet joint joint leakage

When handling, remember to remove the cap nut of the faucet, or re-tighten it, or consider directly using a new u-shaped gasket.

How to install various faucets

1, thermostatic faucet installation

Before installing the thermostatic faucet, be sure to check whether the water pipe is installed with left hot right cold. Before connecting, you must not connect the hot and cold water pipes to the wrong one, and it will not affect the normal use. If you are using gas, solar water heaters, you can't use a thermostat, because the water pressure is too low, it will not achieve the desired effect.

2, wall-mounted faucet installation

When installing the wall-mounted faucet, it is necessary to wash the water pipe first so that it will not cause damage to the faucet. The distance between hot and cold water pipes is also controlled during installation. Its distance is generally controlled at 15. Cm, if less than this distance will affect the use.

3, single hole faucet installation

The single-hole faucet should also pay attention to when installing, this kind of faucet is installed in the kitchen more frequently, at the same time also is the use frequency is high, the long time is easy to appear the loose phenomenon, therefore the lock nut must tighten it well.

4, single hole basin faucet

In the installation of single-hole basin water dragon, some details should also pay attention to, the same can not forget to flush the water pipe buried in the wall before installation, if you find the home water inlet pipe is too long, this time can be intercepted according to their own needs, but Here to remind you not to 90 degrees or greater than 90 degrees.

Summary: About repairing faucet method introduction and how to install relevant content on various faucets is introduced here. When repairing faucets , it must be handled according to practical reasons. Only in this way can it be handled well. At the same time, it is also necessary to install faucets according to the faucets. Styles come. I hope that the above introduction will help everyone.